Stokerforum
Pillefyr => Boink, Scotte, Woody, Biocomfort, RTB => Emne startet af: Fionn efter Apr 06, 2021, 17:12
-
Hi All
I am located in Ireland so apologies for the post in English.
My burner stopped working last weekend and I found the heater element was burned out. I replaced the element but now I am Getting 4 dashes (----) instead of it starting. I have replaced the optical sensor and also the plug connector to the burner but still no joy. The auger motor normally runs for a second when plugged in ( possibly a self test). This does not happen any more so it looks like the controller is not providing power.
I disconnected and reconnected the plug to the burner with power on so is it possible I "spiked" the controller and did damage?
All wires are connected and the fuse is ok.
It is an old orange controller with red segmented LED display.
I have searched all day on google For a replacement but cannot find a one for sale and parts are very difficult to find in Ireland.
Does any body have a link for replacement controllers or is there another model that I can fit instead?
Or can these be repaired or tested
Thank you
Fionn
-
Hi Fionn
It's an old V4 controller you have.
I can recommend to replacing it with a V7.
It is a much more modern and up-to-date mcontroller, with a lot of new features.
NBE has no dealers in Ireland, but I wonder if we can't find a dealer in Denmark who will send a control to you.
Hedestoker is one of the major dealers in Denmark, you can try to contact them.
https://www.hedestoker.dk/
-
Thank you Kenneth.
It is very difficult to find parts here. I'll Try your link and see if they ship to Ireland.
The date on my board is 1/11/2004 so its probably time to update it
Thanks
Fionn
-
Hi.
I Have E mailed Hedestoker twice inquiring if they ship to Ireland and a cost for shipping but have not got a reply.
Does anybody know if the Company is still open or are they closed due to COVID?
Regards
Fionn
-
There had been a slight lack of communication at Hedestoker.
There should be an email on the way soon :)
-
Thank You Kenneth.
Email received and they do ship to Ireland. ;D
I have my V4 controller connected to a zero volt timer to control it.
Do you know if this same timer (zero volt) can be used to control the V7 controller?
Is there a wiring diagram available to connect the 12 pin print board to the fan and the rest of the parts?
Thanks again
Fionn
-
All electrical diagrams can be found at NBE.dk
https://www.nbe.dk/manualer-nbe/
And yes, there is an zero volt "ext" connection on the V7 print, but there is an very nice timer function in V7 ;)
-
Hey - i'we had a fine contact with Hedestoker recently. Do you have the correct email or call them on Tlf. 96 92 10 90
E-mail: salg@hedestoker.dk :)
-
Hey - i'we had a fine contact with Hedestoker recently. Do you have the correct email or call them on Tlf. 96 92 10 90
E-mail: salg@hedestoker.dk :)
Du læser vist indlægget forkert, der er skabt kontakt, der var sket en fejl ved Hedestoker så jeg kontaktede dem, og de fandt mailen og fik svaret.